28 Piece Deluxe Motorcycle Engine Casing Abr and Polishing kit.+Belgom Save 10%

Note: This kit includes abrasive rubber points and felts needed to clean counterbores, recesses and hard to reach places.

This kit is designed to be used with a hand drill, the kit removes medium to light scratches, from motorcycle aluminium engine casings, hole recesses and polishes to a high finish. The kit is supplied complete with abrasive rubber points so abrasive work can be done in the small hard to reach places, 300 grit satene applied on a felt can be used after the rubber points for final abrasive preparation, Following this a polishing compound is applied on an alternative felt and final finishing can be achieved on the tricky bits. (This kit is designed with the enough coloured mops, saving time on any wire brushing between abrasive applications) The 4″ sisal, white stiched, and calico polishing mops, along with the 3″ coloured mops can also be mounted on a bench polisher.

The Kit Can Also be be used on a bench polishing machine 6 inch mops are available, (See Options menu) also a set of alternative smaller 3 x 1/2 inch mops,are available for use on a hand drill.

The kit is also suitable for polising the following:

motorcycle aluminium levers
footrests
small to medium areas
rear subframes
forks
yokes

To remove heavier scratches contact us for more information

Kit contains:

1 x 1 x 1 sial start mop
1 x 1 x 1 white stitched mop
1 x 1 x 1 Calico finishing mop
1 x 2 x 1 Sisal start mop
1 x 2 x 1 white stitched mop
1 x 2 x 1 calico finish mop
1 x 3 x 1 sisal start mop
1 x 3 x 1 stitched middle mop
1 x 3 x 1 calico finish mop
4 x 10 x 10 felt cones
4 x unmounted various felts (large)
1 x 400,800, wet and dry paper
1 x drill arbour
1 x small supercut polish. Included in kit (Not shown in picture)
1 x small white finish polish. Included in kit (Not shown in picture)
1 x Abrasive rubber points 120 grit 10 x 15
1 x Abrasive rubber points 220 grit 10 x 20
1 x instructions.
1 x half bar 240 grit satene
1 x half bar 300 grit satene
2 x 3 x 1 coloured stitched mops
1 x mask

A suitable mask, gloves, goggle and ear defenders should be worn when polishing